|
| shadsky_1 |
|
||
|
Can somebody please tell me correct and best method of tensioning down head. I am installing NEW head from Ford with new head bolts. Unfortunately could not get a head gasket for AU this morning from Dominelli Ford so must use stock one that came in the kit. I have access to normal tension wrench and Disc to tension by degrees. Thanks for any help.
|
||
| Top | |
||
| twr7cx |
|
|||
|
Best way is to follow the instructions on the head gasket or that came with the new head bolts.
|
|||
| Top | |
|||
| stomper |
|
|||
|
There is usually a bit of paper that tells you what to do. When i did mt VK there were 3 stages to it.
Stage 1: 40Nm Stage 2: 70Nm Stage 3: 40000Nm Well you get the idea. But it also tells you what ones to tighten. As in 1, 2, 16, 15, 3, 4 and so on
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| The Dog |
|
|||
|
stomper wrote: There is usually a bit of paper that tells you what to do. When i did mt VK there were 3 stages to it.
Stage 1: 40Nm Stage 2: 70Nm Stage 3: 40000Nm Well you get the idea. But it also tells you what ones to tighten. As in 1, 2, 16, 15, 3, 4 and so on ^^^^ 
Stage 1:40 nm stage 2: 90 degrees 
_________________ You'll ride a black tornado across the western sky
|
|||
| Top | |
|||
| stomper |
|
|||
|
The Dog wrote: stomper wrote: There is usually a bit of paper that tells you what to do. When i did mt VK there were 3 stages to it. Stage 1: 40Nm Stage 2: 70Nm Stage 3: 40000Nm Well you get the idea. But it also tells you what ones to tighten. As in 1, 2, 16, 15, 3, 4 and so on ^^^^ Stage 1:40 nm stage 2: 90 degrees bit different for a VK :S
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 49 guests |
