|
| mreb |
|
|||
|
my cars and eb no abs on the RHS the pad isnt contacting fully with the disc on the outside of the disc just changed the calipers with EL ones and the brakes feel better but still the same ,just over 1 cm of the pad not touching the disc and the pad looks like a quarter of the outer pad isnt touching wot could cause this .
|
|||
| Top | |
|||
| nicco |
|
|||
|
maybe caliper isnt aligned properly with the disc, or pad isnt in caliper properly.
is a caliper slide sticking at all? |
|||
| Top | |
|||
| nannas_ed |
|
|||
|
sounds like your caliper slides are sticking. don't stress its an easy fix.
go down to an auto parts store ie burson, repco and grab a tube of pbr rubber grease (approx $7) unbolt your calipers the caliper bolts go through the caliper slides. push these out (2 on each caliper) clean em up with a bit of thinners/turps/metho and lube em with a bit of rubber grease push them back in and move the in and out a few times too spread the grease around clean up any excess and re assemble make sure there is no grease/dirt on the discs and pads
_________________
|
|||
| Top | |
|||
| mreb |
|
|||
|
i changed the calipers with EL ones and greased them up and its got new pads 2 months ago and new discs. the old caliper on the right was sticking bad and warped the disc maybe have to give it some time to wear the pad in properly with these new calipers .
|
|||
| Top | |
|||
| nicco |
|
|||
|
you did get the discs machined didnt you?
|
|||
| Top | |
|||
| mreb |
|
|||
|
not yet only changed the calipers last weekend i have a feeling the master cylinder isnt working right when driving and i have to stop the pedel feels soft and the RHf brakes shakes then i take my foot of and put it back the pedel feels hard and it brakes smoothly .would a non ABS master cylinder from a EL fit on i know the pipes are in different postions just the mounting i need to know about .
|
|||
| Top | |
|||
| MadMatt |
|
|||
|
Bent axle stub? Loose bearings?
_________________ Member Number 8804 |
|||
| Top | |
|||
| GTBob |
|
|||
|
Warped disc needs machining, then rebleed brakes (with the brake warning switch removed) the pads should NOT need bedding in if the disc is running true and machined
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| mreb |
|
|||
|
will get discs done and see how it goes thanks for help with this annoying problem.
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 62 guests |
