|
| stomper |
|
|||
|
2nd time lucky (lost my thread cause battery went flat).
When i got the car the fan didnt work on 1 or 2. Now it only works on boost. So i did a search and found Hyena's thread where he had the same issue. Here is the threa Hyena's Fan Thread. I went and pulled it out and it looks like this. 
All three coils seem to be ok. They arnt broken. But is this the Fan Speed Resistor? 1 - Is there anything i should do before i go get a replacement resistor? 2 - Would the resistor cause this? 3 - Could i put a bit of wire across 2 of the poles and see if 1, 2, or 3 acts as boost? I also pulled out a few pine needles and leaves. Its damn discusting in there.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| twase |
|
|||
|
That is the control resistor alright, if the coils are intact then chances are its OK. Most likely cause is the switch is faulty.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| snap0964 |
|
|||
|
You can measure the coils and see if they are electrically ok. Maybe the plug connectors are a bit dirty, not seated properly.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| stomper |
|
|||
|
twason wrote: That is the control resistor alright, if the coils are intact then chances are its OK. Most likely cause is the switch is faulty.
Funny you say that eh...... I pulled the switch apart and cleaned it and re-assembled it and then tested with a multi-meter and it was all good. Might have a look at the connections. Its damn annoying only having boost.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| twase |
|
|||
|
If you are handy with the multimeter then as Ray said meter the coils and wiring. If it still does not work then a long shot may be the motor bearings are shot and it requires max power to start it and keep it turning.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| stomper |
|
|||
|
twason wrote: If you are handy with the multimeter then as Ray said meter the coils and wiring. If it still does not work then a long shot may be the motor bearings are shot and it requires max power to start it and keep it turning.
Motor bearing would explain alot :S
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
| Top | |
|||
| GTBob |
|
|||
|
Also check for items jammed in motor like pieces of paper or leaves
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 61 guests |
