wanted,,,, C4 kickdown rod to suit XY

XY 351, c4,,


anyone,, PM me or call me on 0405163879

make one
1/4 ss rod with rod ends

can u explain that a bit more plz

if i had one to work from,, or even seen one, i could fabricate one,,, i dont

detailed instructions would be awesome,, i need to to help bump up the shift pressures,, gone thru 2 gearboxes in 2 months,, getting a 3rd rebuilt bullet proff, but obviously better with a kickdown rod.

a shaft ( about 1/4 inch round) bent in whatever shape to get from accelerator linkage to kickdown lever , depending on where it can be bolted on the carb you may have to shorten or lengthen the lever on the box
can put rod ends on shaft by putting thread on end with locknuts so its a bit adjustable

some stage 3 (manual) setups dont need vacuum or kickdown

hope this helps a bit