|
smoke_ |
|
|||
|
if you adjust them right, they'll go up and down as per normal. mine have been replaced cause i did the front power window conversion too. they're quick too.
_________________ NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter! |
|||
Top | |
marky d |
|
|||
|
i use graphite powder every time.i used to use grease or spray lube but the liquid lubes end up like glue after a while and cause more problem than you started with.graphite powder is available at most locksmiths as they use it for locks too.dont use wd40 on your locks or you end up with grease stains on your clothes from your keys
_________________ MAYBE YOU WOULD RATHER PUSH YOUR HOLDEN THAN DRIVE MY FORD AND YOU WILL PROBLY NEED TO.
|
|||
Top | |
BuNtEr |
|
||
|
BOSXR8 wrote: i found that if i tightened the bolts all the way it struggled to go up, although when i lossened them a little it went up fine.
Sounds like you need to put 2 washers on the other side between the reg and the inside of the door, sounds like when you said when you tighten them up it stuffs up sounds like its pulling the windows on an angle.
_________________ BANNED |
||
Top | |
ringastinga |
|
||
|
just lubing it up wont do it you gotta fix it mechanically....
open up the door and with the widow up loosen the bolts as stated earlier replace with a smaller guage bolt (thinner) add big washers and move the reg till in correct position and tighten remember to use lock nuts or you'll be repeating this process in a few weeks |
||
Top | |
stomper |
|
|||
|
noobie..stop diggin up old posts
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
Top | |
stomper |
|
|||
|
noobie..stop diggin up old posts
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
Top | |
BuNtEr |
|
||
|
s**t i just noticed the date lol, i will take better notice from now on.
_________________ BANNED |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 37 guests |