|
| pinkbits8u |
|
|||
|
what are scat h beams like , ive heard of a few brakages of the i beams
what are probe and srp pistons like - where are they forged and machined im building a stroker with a 6-71 , that will go to about 7 rpm and do the odd burnout comp any suggestions |
|||
| Top | |
|||
| EBXR8380 |
|
|||
|
Scat and Eagle are good gear..Though I went with Oliver when it came to rods in my combo...Bad tune and detonation will kill any engine though...
What type engine ? In most cases these rods are stronger than block strenght...
_________________ As in ZOOM 126 edition |
|||
| Top | |
|||
| pinkbits8u |
|
|||
|
cleveland
i found out srp pistons are je so they are ok i had a look at scat h beams and scat crank 2day and the rods r very much like carillos rods are bronze allooy bushed small ends with scat/ arp bolts the srps seem ok also - the oil ring has lube going into the gudgen also |
|||
| Top | |
|||
| xcabbi |
|
||
|
7 rpm eh? that's a pretty low revving motor.
My mate is building a 383 holden stroker to run on nitrous and he's using scat rods. He swears by the stuff. |
||
| Top | |
||
| pinkbits8u |
|
|||
|
yeh it needs a pretty trick convertor and gearing for the 7revs
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 19 guests |
