now i know i have asked this question before but i want to know how

when removing the spoiler and badges from your car what did you use to fill in the holes??? and how??

i have removed the futura badge and its all smicked out...but now my aim is to get rid of the ford badge and the falcon badge

also i have a towbar and it is ugly as all hell...how 2 get rid of it...i know i can unbolt it but is their something i can have made up to fill in the hole?

don't know for badge hole but hole for towbar there a filler plates for au fairlanes so if your hole is smaller get an au cap and cut you hole to size then if you need to tow you just pop it out

i used a tickford badge to fill in the holes where the original falcon badge was, looks a lot cleaner...

as for the spoiler holes i used caps that push through the holes and then are stuck in... but they are not water tight, far from it... it's easier just to buy a new boot... i ended up putting my spoiler back on, and it looks a lot nicer i think..

well properly you would use weld or metal then rub back and paint again??