|
Mac Winter 76XB351GS |
|
|||
|
Gday,
I am building a supercharged clevo and when trying to bolt up my extractors I ran into a little trouble. All the bolts went in fine except for one...and it would seem that the passenger side bank is warped. So I have had to bite the bullet and order a new set of Genie big bore headers. My mechanic as reccomended that I use heat wrap on the primaries because the new set up will pump out some serious heat. Is there anything I should or shouldn't do when putting it on? Cheers, Matt
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
Top | |
Munch |
|
|||
|
matty, If you're keen on the Genies, they offer a heat coating for not much more, looks neat as, not like the wrap!
_________________ mmmmmmmmmunchy! |
|||
Top | |
ltd351T |
|
||
|
paint the pipes in exhaust paint or fire place paint, run them on the car for a little while to bake the paint, then wrap them in the heat wrap, wet it before you wrap, it will be neater if applied when wet.
|
||
Top | |
Mac Winter 76XB351GS |
|
|||
|
Thanks guys. I'll get them coated and make a heat shield for my starter motor. Have to find out how much they are with the ceramic coating.
_________________ 76XBGS, 383c, custom crow cam, 4V p&p heads, Isky SS Valve+springs, extractors, 2.5"twins, MSD Ignition, Edelbrock intake, Forged bottom end, Barry Grant 750DP, thermo, discs, toploader, Holley fuel pump, SUPERCHARGED! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 21 guests |