Fordmods Logo

BLOWNC is running! Need help with idle 

 

Page 2 of 2 [ 30 posts ] Go to page Previous  1, 2

 
Posted: Sun Dec 16, 2007 10:31 pm 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 451

Joined: 5th Nov 2004

Ride: 5lt Turbo NC, TE V6 Gemini

Location: Castlemaine
VIC, Australia

ok.... im getting somewhere. If i leave it overnight then try to start it, it starts easy and idles rough but doesnt stall. It revs cleanly now...but after a few mins it develops its nasty idle again (stalls if i take my foot off the throttle), but if i maintain the idle with the throttle, its ok and it still revs cleanly...still have the stock fuel reg...Could it just be running really rich and fouling the plugs? Could it be a timing issue? Without a AFR guage im still just guessing bout it running rich, but its blowing plenty of fuelly black smoke... and this is all while sitting in park, if that matters?
Top
 Profile  
 
 
Posted: Mon Dec 17, 2007 12:33 am 
Stock as a Rock
Offline

Posts: 149

Joined: 28th Sep 2007

Power: 192 rwkw

Location: kadina
SA, Australia

ok definately sounds like its fouling the plugs

2 options

1 way too rich

2 timing way retarded

try setting the timing to stock + 2degrees and see if it idles and revs ok

btw ur plugs will need a realy gd clean by now
idealy get new set
Top
 Profile  
 
 
Posted: Mon Dec 17, 2007 8:10 pm 
Getting Side Ways
Offline

Age: 44

Posts: 661

Joined: 2nd Dec 2004

Ride: AU XR8

Location: Wollongong
NSW, Australia

A wideband AFR is nice to have, but its not going to help if you've got nothing to tune the engine with.

There are a couple of cheap twEECers floating around at the moment, I would spend the money on one of those before I worried about a wideband.
Top
 Profile  
 
 
Posted: Mon Dec 17, 2007 9:46 pm 
Getting Side Ways
Offline
User avatar

Age: 71

Posts: 3555

Joined: 7th Nov 2004

Gallery: 4 images

Power: 482 rwkw

Location: Penrith
NSW, Australia

Register here.. So much info on eec forced induction engines..
http://www.corral.net/forums/forumdisplay.php?f=311

If you are after parts ???In this case fuel related...
http://www.corral.net/forums/forumdispl ... e=30&f=323
This may be of interest to you..
http://www.corral.net/forums/showthread.php?t=885978
Hope this helps ..
Graeme...

 

_________________

As in ZOOM 126 edition
331 Dart block,3.25/ 4340 steel crank, Oliver rods,TFS ported track heat heads, TFS track heat inlet Twin SC61 turbo's
Project 1UZ-EF has started.. S475 Turbo 4.0 V8 Mustang Celica.....

Top
 Profile  
 
 
Posted: Tue Dec 18, 2007 11:08 pm 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 451

Joined: 5th Nov 2004

Ride: 5lt Turbo NC, TE V6 Gemini

Location: Castlemaine
VIC, Australia

ok...ive read all the threads and i think i may have a tweecer on the way...but my problem is that im not sure bout what my base timing is?? On the balancer...looking from above you have a zero marker, then points to the left and points to the right. Now i know this is a real newbie question...but im thinking if the book says 30degress it should be on the 30 marker to the RIGHT of the zero?
Top
 Profile  
 
 
Posted: Wed Dec 19, 2007 10:34 am 
Getting Side Ways
Offline

Age: 40

Posts: 868

Joined: 23rd Sep 2005

Ride: eb falcon

Location: kadina
SA, Australia

if the writing is on the balancer itself, then you are correct.. if the numbers are on the timing cover, then you need to be to the left of zero

 

_________________

EB 4L, 8.4:1, R154, GT4202r, 4in exhaust, Greenslade Engineering exhaust manifold, plenum chamber, 90mm throttle, Garrett W2A cooler, Surecam custom, autronic SM4, Bosch 120lb, Crane HI-6, LX-92, LM-1, Turbosmart Reg, 2x bosch 044, turbosmart 48 gate. 470kw+ @ 18PSI

Top
 Profile  
 
 
Posted: Wed Dec 19, 2007 9:55 pm 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 451

Joined: 5th Nov 2004

Ride: 5lt Turbo NC, TE V6 Gemini

Location: Castlemaine
VIC, Australia

Just as a way of solving the idle while i await my tweecer...if i were to fit a 1:1 adj fuel reg and wind the fuel press down a bit...would that stop the car running overly rich on and slightly above idle? All i want to do with the car atm is move it around my yard and on/off my trailer (i dont have a winch)...would it work in stopping the plugs from fouling? Remember im not driving the car on the road yet, i just wanna solve the idle problem?
Top
 Profile  
 
 
Posted: Wed Dec 19, 2007 11:18 pm 
Stock as a Rock
Offline

Posts: 149

Joined: 28th Sep 2007

Power: 192 rwkw

Location: kadina
SA, Australia

hav u adjusted your timing? did that help?
Top
 Profile  
 
 
Posted: Wed Dec 19, 2007 11:51 pm 
Getting Side Ways
Offline
User avatar

Age: 71

Posts: 3555

Joined: 7th Nov 2004

Gallery: 4 images

Power: 482 rwkw

Location: Penrith
NSW, Australia

Try std injectors ??? I'd say eec is on limp mode ??

 

_________________

As in ZOOM 126 edition
331 Dart block,3.25/ 4340 steel crank, Oliver rods,TFS ported track heat heads, TFS track heat inlet Twin SC61 turbo's
Project 1UZ-EF has started.. S475 Turbo 4.0 V8 Mustang Celica.....

Top
 Profile  
 
 
Posted: Wed Dec 19, 2007 11:53 pm 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 451

Joined: 5th Nov 2004

Ride: 5lt Turbo NC, TE V6 Gemini

Location: Castlemaine
VIC, Australia

havent been able to adjust timing as i cant get it to idle :( ill go back to standard maf and injectors, do the timing...then see what happens?
Top
 Profile  
 
 
Posted: Thu Dec 20, 2007 12:13 am 
Stock as a Rock
Offline

Posts: 149

Joined: 28th Sep 2007

Power: 192 rwkw

Location: kadina
SA, Australia

yep sounds like a plan

lets us know where it was at
Top
 Profile  
 
 
Posted: Thu Dec 20, 2007 10:24 pm 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 451

Joined: 5th Nov 2004

Ride: 5lt Turbo NC, TE V6 Gemini

Location: Castlemaine
VIC, Australia

quick update...ive swapped back to the stock injectors and maf and im no longer feeding it boost..however it still runs like a**... havent cleaned the plugs yet, so im off to do that and ill report back
Top
 Profile  
 
 
Posted: Fri Jan 04, 2008 9:51 pm 
Getting Side Ways
Offline

Age: 39

Posts: 942

Joined: 23rd Dec 2007

Ride: AU1 XR8

Any change yet




Brad
Top
 Profile  
 
 
Posted: Fri Jan 04, 2008 10:23 pm 
Getting Side Ways
Offline
User avatar

Age: 71

Posts: 3555

Joined: 7th Nov 2004

Gallery: 4 images

Power: 482 rwkw

Location: Penrith
NSW, Australia

Was it confiscated ???? Lol....

 

_________________

As in ZOOM 126 edition
331 Dart block,3.25/ 4340 steel crank, Oliver rods,TFS ported track heat heads, TFS track heat inlet Twin SC61 turbo's
Project 1UZ-EF has started.. S475 Turbo 4.0 V8 Mustang Celica.....

Top
 Profile  
 
 
Posted: Sun Jan 06, 2008 1:25 am 
Getting Side Ways
Offline
User avatar

Age: 41

Posts: 451

Joined: 5th Nov 2004

Ride: 5lt Turbo NC, TE V6 Gemini

Location: Castlemaine
VIC, Australia

No update yet...had a few dramas as of late and i haven't even been in the shed since the last post...however i've decided upon a Haltech Interceptor which will be arriving this week hopfully and have found a tuner who has a good rep and is full of promises...ill post results as soon as i have them
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 30 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 30 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Tue Dec 24, 2024 2:58 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names