|
| JT |
|
||
|
Ok, in an attempt to fix my lifter noise I tried to buy a new set of HLA's but they (repco) only sell the small ones for EF onwards..
Can I bolt a full rockergear set off a EF/EL onto my EBII motor so that I can get new HLA's?? Same engines right? Last edited by JT on Sun Jan 06, 2008 10:54 pm, edited 1 time in total. |
||
| Top | |
||
| tickford_6 |
|
||
Posts: 6449 Joined: 11th Nov 2004 |
yes you can fit the later rocker gear to an early engine.
or you could just go to a different parts place and get the HLAs to suit your engine. |
||
| Top | |
||
| xfman1986 |
|
||
|
as above
|
||
| Top | |
||
| Kenwood Maverick |
|
|||
|
as stated above, however if your interested on changing the pedestal and rockers get ones out of an EA they are slightly larger. just get new lifters for it
|
|||
| Top | |
|||
| JT |
|
||
|
so where can I get the large HLA's from? As repco doesn't have them..
and ford want $65 each for them here! |
||
| Top | |
||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
just replace the ones that dont spring back in your hand when you compress them. They will be the ones that have the most tick.
|
||
| Top | |
||
| JT |
|
||
|
can anyone tell me which one of these is the smaller HLA's ? 
|
||
| Top | |
||
| Johnson stroker |
|
|||
|
yeah should be the dirtiest of the lot they look like EF EL ones, the smaller almost pin sized hole on the top is a give away, the other look like EA and EB-ED ones. can anyone else confirm?
100% certain the EF EL ones are correct.
_________________
|
|||
| Top | |
|||
| JT |
|
||
|
what is the clean one then? Does anyone else think that the smaller HLA's are less prone to noise?
|
||
| Top | |
||
| phongus |
|
|||
|
I think the cleaner one is out of an EA, the middle one is out of maybe an EBII or ED and the last one is out of an EF/EL...since they look the same as mine.
phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| JT |
|
||
|
sweet.. and I can put EL/EF ones on my EBII head yeah?
|
||
| Top | |
||
| poita |
|
||
|
Mate, you can get a set of large HLAs from 'Coastal Engine Services' in mornington.
ph: +613 5976 2947. that is if you wanna get 'em shipped to you. i got my HLAs from them, not only did they fit (yes i have an EL but they first gave me early series HLAs) but they were fully metal, no nylon. take care & good luck pete
_________________ Is the noise in my head bothering you? Because the noise in yours is annoying the s**t out of me.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 67 guests |
