|
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
Hi, when i did the adjusting nuts up on my Rollmaster vernier gear i did them up pretty tight cause i was worried the cam gear might slip, also put meduim strenght loctite on the threads
But im afraid ive done them up too tight as the washers have bent into a U shape sinking into the hole. Now am looking for new nuts and washers and just wanna know a good torque setting for these? Also, if anyone knows where to buy the washers, or even what to use instead as i assume you cant just use any washer? |
||
| Top | |
||
| ef_ridin_low |
|
||
|
off topic was it hard to fit this cam gear cause i have one sittin beside me lol
_________________ 95 evlmont fairmont, 5 speed manual, 3.45lsd, rebuilt and recond, port and polished head, wade 1521a cam,ems stinger, garret 3540 1.06 rear, tial 38mm waste gate, turbosmart "supersonic" bov, bosch greentop 42lb injectors,snort log manifold, heavy duty 5 puck ceramic clutch,fmic 600x300x76, |
||
| Top | |
||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
No, its not hard, the only hard bit is after pulling out the middle plug in the tensioner, make sure you pressing on the outside bit of the sleeve when turning to release the tensioner or you'll have to pull out the whole tensioner and piece it together which isnt really hard, but more time spent than you really have to.
|
||
| Top | |
||
| phongus |
|
|||
|
FordFairmont wrote: No, its not hard, the only hard bit is after pulling out the middle plug in the tensioner, make sure you pressing on the outside bit of the sleeve when turning to release the tensioner or you'll have to pull out the whole tensioner and piece it together which isnt really hard, but more time spent than you really have to.
I'm not sure but I would say about 30-40Nm like the cam sprocket, but that's just a wild guess...it might just be a bit less. I doubt it has to be any more then that...and maybe use some medium strength thread lock. phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
thats what i think i did it up to, cause the washers are bent.
i tried googling, and other brands like HKS recommend around 20nm, then another brand only recommend 10nm? Will prolly ring Romac the supplier on Monday |
||
| Top | |
||
| mitchg911 |
|
|||
|
40nm??? theyre only tiny..
just do them up til theyre tight.
_________________ BF XR6T 6spd Auto. 60lb injectors, Hybrid Cooler, Custom Piping, Custom Surge Tank, Actuator. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 131 guests |
