|
heathsedxr6 |
|
||
|
well ive completed everything of the conversion, i mean everything except it wont start even with a manual computer in it so i tried the auto one as well and still got nothing!! It roll starts but sounds like its on 4 bloody cylinders! Any Ideas!
|
||
Top | |
KiwiDazza |
|
||
|
What work have you done, might help with diagnosing the problem.
Have you pulled the codes from the ECU/TCM's ? Have you set the base timing right, out 180Deg perhaps? Plug leads on the right way? Does it turn over with the key. Does it have smartlock, have you done the 30min thing? |
||
Top | |
heathsedxr6 |
|
||
|
It doesn't turn over with a key, it does have smartlock though.. don't know bout the codes because i don't have any idea how to do that. did't adjust any timing and did't take off the plug leads. Wots the 30 min thing?? never heard of it!!
|
||
Top | |
phongus |
|
|||
|
heathsedxr6 wrote: It doesn't turn over with a key, it does have smartlock though.. don't know bout the codes because i don't have any idea how to do that. did't adjust any timing and did't take off the plug leads. Wots the 30 min thing?? never heard of it!!
So what exactly did you do? Did you remove the battery? Does the smart lock light up or flash when you have the key in? If you do, then the BEM does not recognize your key and so you have to input the key again. Leave the key in the Ignition on the On position for about 30-45mins or something. If it isn't your smart lock, check your fuses. phong =P~
_________________ phongus = Post whore 2006 |
|||
Top | |
heathsedxr6 |
|
||
|
ok so it was my loom wasn't the right one, ea and ed looms are different so i got my auto one and did that trick but now it still runs like s**t!!! bloody thing barely idles, and sounds like the timing is out but it isn't! i just want to drive her!! lol
|
||
Top | |
Nicko |
|
|||
|
next time explain what you have done so people can help
your original post is pretty useless and gives no clue how to help you
_________________ Nicko |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 18 guests |