|
| onlinejamez |
|
||
|
how long do you need to hold the earth wire to pin 4 for the reset to work, i thought you needed to hear 4 beeps, havnt heard any yet
still the light flashes in airbag light I keep getting error 34 Resistor or Passenger Airbag Shorted or low Resistance thanks |
||
| Top | |
||
| TwistedEL |
|
|||
|
If it's an EF, 5 seconds. It won't reset if you haven't fixed the problem...
If you have a PAB then check the connection. Otherwise EF Series 1 there is a resistor behind the dash on the right hand side. Series 2 there is a resistor roughly where the PAB should be (much easier to find) |
|||
| Top | |
|||
| onlinejamez |
|
||
|
Its an EL, what does the resistor look like, anyone got a photo of it?
thanks |
||
| Top | |
||
| TwistedEL |
|
|||
|
1) Switch the Ignition On
2) Allow the Code to be Displayed. 3) Apply a Short Circuit to the Airbag Memory Clear Pin of the Diagnostic Connector to Ground (See above Picture for further details). 4) The Code will be cleared after 5 Beeps have sounded. Repeat the Above untill all the required codes have been Cleared. Taken from the tech docs I have a funny feeling it doesn't work on EL and it needs to be cleared by the diagnostic computer at Ford |
|||
| Top | |
|||
| onlinejamez |
|
||
|
i dont get any beeps at all, tried different earth, still nothing, i know the earth is ok, tested with test light
what could be causing this, if its the resistor where could it be, i cant seem t find it thanks |
||
| Top | |
||
| TwistedEL |
|
|||
|
On an EL it's behind the dash where the PAB would be (bright yellow cable running to it)
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
Take the glovebox out, shine a torch through the LHS hole - find the resistor mounted, pull it out and reconnect it, and see if the code is gone.
As mentioned, you won't reset it unless the 'fault' is fixed.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| onlinejamez |
|
||
|
Ive looked for the resister with out much luck im posting couple pics of the glove box area, but the hole you mentioned has a metal plate covering most of it, and the only cable is the aerial lead, so i dont know where it is?
http://i257.photobucket.com/albums/hh23 ... C00153.jpg http://i257.photobucket.com/albums/hh23 ... C00143.jpg |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 64 guests |
