|
| rdiigen |
|
|||
|
doesnt happen alot but is starting to irritate me, on highway cruise at or above 100km it decides out of the blue to slip back into 3rd.
ive checked all the resistances on the inhibitor switch and theyre all within limit, the voltage is good to the switch. my TPS only has 330 ohms throttle open when it should be 500, is this a big issue? anything else i can check? cheers |
|||
| Top | |
|||
| ReGiE |
|
|||
|
what the qualie fluid like? is it low or black?
_________________ Gooooone - Eb2 Coon - 143RWKW |
|||
| Top | |
|||
| eb0 |
|
||
|
yeah i put the wrong fluid in the other night went for a drive the next day same thing happen too my car changed the fluid has not happen again might be worth a try for you
|
||
| Top | |
||
| Low_EFII |
|
|||
|
what the hell is qualie fluid?
|
|||
| Top | |
|||
| eb0 |
|
||
|
Low_EFII wrote: what the hell is qualie fluid?
quality |
||
| Top | |
||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
rdiigen wrote: my TPS only has 330 ohms throttle open when it should be 500, is this a big issue?
the TPS should read between 0.55 and 0.85 at ignition on/car off, and running idle. Should read 4+ volts at full throttle Make sure you earth the multimeter at the negative wire in the tps sensor plug as it will distort the readings if you use the motor or chassis as earth. Also make sure the reading is the same when the ignition is on/car off and the car running |
||
| Top | |
||
| rdiigen |
|
|||
|
it was slipping before and after the automatic service fluid change a few weeks back
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 127 guests |
