|
| WAGHOON |
|
||
|
Has this happend to anyone else? The car is an EF2. I would say the radiator has s**t its self and the trans fluid has leaked into the coolent
 The radiator is a reco'd natrad 14months old  I have never heard of it happening before and just want to know how common it is.
|
||
| Top | |
||
| OBS35N |
|
|||
|
how would this happen?
do u have the tranny cooler that runs through the radiator like in my ef?
_________________ OBS35N is gooonnnneeee.
|
|||
| Top | |
|||
| gogetta |
|
|||
|
I have seen it before, was a while ago but cant remember if it was a ford or not
_________________ |
|||
| Top | |
|||
| natho |
|
||
|
be careful as if water gets into the trans fluid it can eat away at the synthetic parts of the gearbox...
|
||
| Top | |
||
| steven13 |
|
||
Age: 55 Posts: 200 Joined: 27th May 2007 Ride: Ford FG XR6 TURBO Location: Frankston North |
Yeah I had this. F***ed my auto. Cost me $1850 just for Auto then $140 for new radiator. I then bypassed radiator and put after market trans cooler in. Was on special at Repo for $118. It was the biggest they had.
_________________ Current ride Ford FG XR6 TURBO |
||
| Top | |
||
| Paulmac |
|
||
|
Sounds like the Natrad reco wasn't as good as it should have been and a seam has opened up.
The car should not be driven and the radiator should be replaced NOW, Steven13 gives the reason why. If you need to buy time, bypass it with a cooler as Steven13 did and plug up/cap the tran fluid holes in the radiator. [Better/easier if you have a factory cooler already fitted, just get trans. fluid hose lengths fron Bursons etc.] Coolant will burst through the bad seam and pour out of the open tran fluid holes, you'll save the tranny but may cook the motor, no gain there. Probably cheaper to just get a radiator first then fit a cooler, depends what you can get quickest. Paul
_________________ What goes around, comes around. |
||
| Top | |
||
| WAGHOON |
|
||
|
Thanks for the replys fella's. It has a trans cooler but it looks to be a little smaller then a DVD case in size, is this big or small. as far as I know it was fitted in 96 with a towing package from ford. Will that be enough to cool the trany if I bypass the radiator? Should I change to oil in the trany. Thanks........David
|
||
| Top | |
||
| Paulmac |
|
||
|
I believe the Ford coolers were meant to assist the radiator based cooling in a towing scenario, not replace it. A larger aftermarket cooler would be better for a permanent change or hard, hot use.
For emergency use, with average driving conditions, it should suffice IMO. If you want to bypass the radiator, leave the nuts in and some pipe on the radiator fittings when you cut the tran fluid pipes. It's easier to seal them up with a bolt, a piece of hose and small hose clamps than find caps for the radiator fittings. It's probably wise to replace the fluid and internal filter, depends on if you can check its condition. Cheers, Paul
_________________ What goes around, comes around. |
||
| Top | |
||
| WAGHOON |
|
||
|
Thanks mate, I think I will just get a new radiator
|
||
| Top | |
||
| Paulmac |
|
||
|
Best move for sure,
Cheers, Paul
_________________ What goes around, comes around. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google [Bot], Google Adsense [Bot] and 31 guests |
