|
| gogetta |
|
|||
|
does anyone have a pic showing which solinoid the S2 is??
going to have a go at changing it cause i think mine is stuffed
_________________ |
|||
| Top | |
|||
| snap0964 |
|
|||
|
What fault codes are coming up??
What symptoms are you having with the BTR transmission??
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| jrfttf |
|
||
|
pm sent!
|
||
| Top | |
||
| gogetta |
|
|||
|
snap0964 wrote: What fault codes are coming up??
What symptoms are you having with the BTR transmission?? its not kicking down very well wont hold gears manually sometimes goes to LHM, but ok after ON/OFF
_________________ |
|||
| Top | |
|||
| jrfttf |
|
||||
|
diagram
|
||||
| Top | |
||||
| gogetta |
|
|||
|
ill have to see how that compares to the actual GB
thanks
_________________ |
|||
| Top | |
|||
| garthr |
|
||
|
gogetta wrote: does anyone have a pic showing which solinoid the S2 is??
going to have a go at changing it cause i think mine is stuffed pretty sure that once u remove the oil pan and look up at valve body, each solenoid has its number cast into the valve body next to it (in fairly large lettering too)
_________________ Garthr
|
||
| Top | |
||
| joolz |
|
|||||
|
As shown in pic soleniod 2 (S2 as marked on valve body) is on the bottom left. Not all soleniods are fitted as some have been removed. You can either use a torx bit or a tight fitting allen key to remove the screw. But first make sure the large round plug going into the trans has clean pins and fitted all the way, then erase all fault codes to ensure you arent reading an old one. Then drive the car until it faults. If it does then read the fault codes as they will be current ones.
|
|||||
| Top | |
|||||
| Who is online |
|---|
Users browsing this forum: No registered users and 61 guests |
