|
| lb4sl |
|
||
|
Hi folks,
I have checked the site fro the symptoms and think my ED Futura BCM bit the dust. I have replaced the BCM - done the famous "30Minute" thing and still not firing. Stock standard Futura, ED, 1994 Engine is turining over and not starting Central lock, boot and petrol release not operating. Driving along and it cut out. When replacing the BCM the jewel was flashing. It had stopped by 30 minutes Smartlock comes on when turining key to "ON" and then then goes off. I am at a loss now. Help!!! p.s. Somewhat peeved that such a trivial thing as a PCB failure cna disable a perfectly mechanically sound car! Going to get that 63 Mustang I want!!! 
|
||
| Top | |
||
| luthor |
|
||
|
When you say it is not firing what do you actually mean? There is no BCM on an ED, are you talking about the Smartlock Module?
|
||
| Top | |
||
| KiwiDazza |
|
||
|
I would love to see your chances of getting a 63 mustang! unless you are talking about some type of boat.
seriously I had a buggered wire which gave the same symptoms. Give the pins a check first to make sure that the corrcet voltages are going into and out of the module. |
||
| Top | |
||
| bArNsY |
|
|||
|
the problem will most likely be the smartlock module not the BCM.
Did the door locks cycle over? as the recognition of new smartlock/ignition will not be recognised until this is done
_________________ FG G6E Turbo |
|||
| Top | |
|||
| Paulmac |
|
||
|
As above, are you referring to the RED module?
I just replaced the red Smartlock module, located behind the plastic fascia, above the handbrake handle [easier access with the cluster out] on my 'new' ED T5 Futura for the same symptoms. I had to hold the key in the FULL start position and bang the plastic above the handbrake handle to re-start every time BenJ and I stopped between Wagga and home on Easter Sunday. Easter Monday put in an EB2 module, waited 30mins, ign on, all fixed. Cheers, Paul
_________________ What goes around, comes around. |
||
| Top | |
||
| bArNsY |
|
|||
|
check the ignition wires for wear and the ignition assembly itself
_________________ FG G6E Turbo |
|||
| Top | |
|||
| luthor |
|
||
|
[quote="bArNsY"]the problem will most likely be the smartlock module not the BCM.
Thats right because ED's don't have a BCM. |
||
| Top | |
||
| fairmont 1 |
|
||
|
yes they do, even eb2s had bcms.
the smartlock module is red and the fairmont bcm is green and i think the futura/xr bcm is blue but youd have to check first and im not sure on the gli bcm. bcm is on the right hand side of the stereo sitting vertical next to the smartlock module which is sitting horozontal above the hand brake |
||
| Top | |
||
| edfairmont4.0 |
|
|||
|
lol no ed's dont have a bcm so all the electrics in the car are controlled magically..... yes as above mentioned it will be the red box I was in belief it took and hour to synchronize it with the car ignition on and wait for door locks to cycle
ive had 2 ed's and the smartlock modules are a pain in the a**, both my ed's modules need to be hit to make it run at times... one it wouldnt crank till you hit it and the other wouldnt send the enable signal to the ecu so just cranking.
_________________ ED Fairmont, Ghia mock DOHC-T 11.6 @ 118 Trying to get back to the 1/4! |
|||
| Top | |
|||
| fairmont 1 |
|
||
|
i saw another box in a eb2 fairmont at the local scrap yard which is a bcm which is green and i saw a red box as well if you open your dash board youll see it nest to the radio.
ask someone on ford forums if you really want to |
||
| Top | |
||
| luthor |
|
||
|
The BCM you guys are refering to is actually called a Central Controller on E series up to ED, and has very limited functions .
|
||
| Top | |
||
| KyleBardell |
|
|||
|
check your fuses, i had a similar problem a while back.
_________________ The Luxo Cruiser - 07 BF Fairlane |
|||
| Top | |
|||
| bArNsY |
|
|||
|
BCM/Central Controller is the same thing
On the EDs: Low Series - BLUE - 1 plug High Series - GREEN - 2 plugs RED - Smartlock
_________________ FG G6E Turbo |
|||
| Top | |
|||
| luthor |
|
||
|
{USERNAME} wrote: BCM/Central Controller is the same thing
On the EDs: Low Series - BLUE - 1 plug High Series - GREEN - 2 plugs RED - Smartlock The Ford BCM, or BEM to use it's correct term, as used on EF's etc, is an integrated module combining central controller, smartlock and many other functions, unlike the simple C/Controller. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
