Fordmods Logo

need advice 

 

Page 1 of 1 [ 8 posts ] 

 
 Post subject: need advice
Posted: Tue Jun 03, 2008 10:31 pm 
Stock as a Rock
Offline

Age: 40

Posts: 177

Joined: 9th Nov 2004

Ride: EF FAIRMONT

Location: melbourne
VIC, Australia

was out at calder last friday night and manage to run a 14.2 at 100mph on 7 psi with my standerd computer and injectors in place with rising rate fuel reg. (wolf and 550s not fitted yet) had a good 2.o second sixty foot but 14.2 is dissapointing. i know i need to get it tuned but been lazy, it has a stock motor with 170 psi in each cylinder so comp is not an issue. turbo is an off the self garrett t66 turbo with ar70 comp not to sure on turbine but think it is 1.02. car runs a manual with 3.45 gears so pull in first and second in sweet but put it in third and is lagy untill about half way throu.
car still has a 1673 cam so thinking going back down to a 1604 wade cam might help plus with the tune and bigger injectors.
i wont to keep this car manual cause its more fun just dont wont the lag.

any help on making it less laggy wouldbe nice thanks guys

 

_________________

WOLF V500, t66(ar70 compressor), rochester 550cc injectors, borgg 265l fuel pump, 48mm turbosmart gate, turbosmart plumb back bov, 600x300x100 cooler, 3 inch zorst , 3.45 lsd, xr6 head, wade 1604 cam, adjustable cam gear, K&N pod filter, on 10psi and manual convertion exedy button clutch. 285.6rwkw

Top
 Profile  
 
 
Posted: Tue Jun 03, 2008 11:12 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 2057

Joined: 25th May 2006

Ride: ef xr8

Power: 229 rwkw

Location: Perth
WA, Australia

I'd be looking to get the tune done asap.


Dunno, with those sixty foot times it looks to be going hard off the line, maybe its the top end, either a bit rich or lean and it will cost the top end.

Maybe a dyno run and check Air Fuel Ratio's, if they check out to be fine, then I'd be looking at your driving. :D

 

_________________

Because of Beer, Thirst is a Beautiful Thing!

'95 EF XR8 auto, Advance headers, 3" exhaust, Cobra manifold, BBK 75mm throttle body , 80MM Marauder MAF, Vortech V2 T Trim , 307 rwhp, 405 ft/lb 13.2 @ 105 MPH

Now N/A (permanent Lag) - AFR 165's, Comp XE270 cam, 1.6 RR - 269 rwhp 14.1 @ 102mph.

Top
 Profile  
 
 
Posted: Tue Jun 03, 2008 11:26 pm 
Getting Side Ways
Offline
User avatar

Age: 36

Posts: 975

Joined: 26th Nov 2004

Ride: el falcon

Power: 608 rwkw

Location: Waroona
WA, Australia

leave the cam its not the problem, but u could advance it alittle.

it just needs a tune it would be to rich, with incorrect ignition advance.

 

_________________

# 1997 EL Falcon GLI - 600+rwkw

# 2008 FPV FG GTE - Xa Coilovers, 20x8/ 20x10 Fairladys

Top
 Profile  
 
 
Posted: Wed Jun 04, 2008 10:33 am 
Getting Side Ways
Offline
User avatar

Age: 71

Posts: 3555

Joined: 7th Nov 2004

Gallery: 4 images

Power: 482 rwkw

Location: Penrith
NSW, Australia

You will get far less lag with auto and heaps better 60Ft times.. The turbo spools on converter BEFORE the go light comes on.. The turbo won't spool on rpm alone.. I suggest get it tuned properly and set up a two step rev limiter so it builds boost while staging... In effect it becomes a pre stage anti lag program... Hope you don't have a T5 tranny...

 

_________________

As in ZOOM 126 edition
331 Dart block,3.25/ 4340 steel crank, Oliver rods,TFS ported track heat heads, TFS track heat inlet Twin SC61 turbo's
Project 1UZ-EF has started.. S475 Turbo 4.0 V8 Mustang Celica.....

Top
 Profile  
 
 
Posted: Wed Jun 04, 2008 10:42 am 
Getting Side Ways
Offline
User avatar

Age: 38

Posts: 886

Joined: 17th Aug 2005

Gallery: 24 images

Ride: VZ SS 6Ltr ute, Honda VFR800

Location: Melbourne
VIC, Australia

Get an auto with a 3000rpm stall!! shouldn't have much lag issues then, and you should get faster times as well :)

 

_________________

My Cars
2006 VZ SS cammed 6Ltr ute 295rwkW
2004 BA XR6T - 290rwkW 12.5@113mph ( SOLD )
1996 EFII Fairmont - 130rwkW 15.5@91mph ( SOLD )

Top
 Profile  
 
 
Posted: Wed Jun 04, 2008 2:05 pm 
Stock as a Rock
Offline

Age: 40

Posts: 177

Joined: 9th Nov 2004

Ride: EF FAIRMONT

Location: melbourne
VIC, Australia

wont to keep it manuel
yes it t5(i know cant affort tko yet)
it starts to lagging under full load at the start of third ????????
and no its not my driving

 

_________________

WOLF V500, t66(ar70 compressor), rochester 550cc injectors, borgg 265l fuel pump, 48mm turbosmart gate, turbosmart plumb back bov, 600x300x100 cooler, 3 inch zorst , 3.45 lsd, xr6 head, wade 1604 cam, adjustable cam gear, K&N pod filter, on 10psi and manual convertion exedy button clutch. 285.6rwkw

Top
 Profile  
 
 
Posted: Thu Jun 05, 2008 2:50 am 
Getting Side Ways
Offline

Age: 40

Posts: 868

Joined: 23rd Sep 2005

Ride: eb falcon

Location: kadina
SA, Australia

Graham - your one funny guy, you just used these words all in the same context...

Two-Step
Anti-Lag
T5....

hahaha..

on the topic though, theres no point chasing possible solutions, without first checking some vital signs... a/f and ign for starters

 

_________________

EB 4L, 8.4:1, R154, GT4202r, 4in exhaust, Greenslade Engineering exhaust manifold, plenum chamber, 90mm throttle, Garrett W2A cooler, Surecam custom, autronic SM4, Bosch 120lb, Crane HI-6, LX-92, LM-1, Turbosmart Reg, 2x bosch 044, turbosmart 48 gate. 470kw+ @ 18PSI

Top
 Profile  
 
 
Posted: Thu Jun 05, 2008 2:59 am 
Getting Side Ways
Offline
User avatar

Posts: 3331

Joined: 27th Dec 2004

Gallery: 4 images

Ride: MCMXCV Falcon

Location: G town
VIC, Australia

{USERNAME} wrote:
You will get far less lag with auto and heaps better 60Ft times.. The turbo spools on converter BEFORE the go light comes on.. The turbo won't spool on rpm alone.. I suggest get it tuned properly and set up a two step rev limiter so it builds boost while staging... In effect it becomes a pre stage anti lag program... Hope you don't have a T5 tranny...


how does the 2 step and anti-lag work basically?

 

_________________

Image

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 8 posts ] 

Who is online

Users browsing this forum: No registered users and 40 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Mon Dec 23, 2024 10:46 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names