|
blacksabbath189 |
|
|||
|
ok don't crusify me fella's
but i'm trying to fix my mates VS commy... quick jerk of the throttle, it almost die's in the a**, underload, with any sort of acceleration, it misses/surges.. what i've done to try and rectify problem: - removed leads, tested resistance, was abit high on a couple, so got some cheap from the wreckers which are fine ( no difference ) - checked spark plugs, re-gaped plugs, gave them a clean - they seem ok. - then i thought after those simple few things, i better check the fault codes.. 46 - no reference signal while cranking 47 - crank angle reference signal so armed with that information, i assumed it was the CAS (crank angle sensor) got one from wreckers, replaced it, and then as i was just about to start it i was thinking the CAS wouldn't cause a miss...and indeed it didnt.. so checked fault codes again, same problem, then i realised the CAS signal runs through the DFI module, so i took it off, cleaned coil packs and module as they were quite dirty.. put it all back together.. ( no f**k difference ), so i went and got a DFI module from wreckers, replaced it ( no f**k difference ) ...and now the fault codes have vanished.. so i'm out of ideas, if anyone could help me? the 9 pound sledgy is eyeing it off, and i think its going to feel PAIN.. any help would be greatly appreciated, thanks
_________________ Slavery, gets s**t done! |
|||
Top | |
SgtBourne |
|
||
|
timing completely rooted? injectors shagged? fuel filter clogged
_________________ So much RAM the motherboard twisted off the POST. |
||
Top | |
blacksabbath189 |
|
|||
|
checked fuel pump operation, theres a nice even flow..
next thing on my list is timing, if thats ok, then i'll do a compression test!
_________________ Slavery, gets s**t done! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 77 guests |