ok guys im not far off finishing my XC and i need them soon as iv beeen working on it over a year and i realy want to drive it,

black capret to suit sadan

DO REALY NEED Hydrolic clutch set up, pedel, lines, slave, master, i know my chances are little but i will take any part i can get aslong as its in good working order,

looking for a XC V8 radiator, in sa as its too big to post will drive <100 kms unless its in mt gambia or penola or neer as i will be there on the weekend


let me know Thanks Tom

http://cgi.ebay.com.au/MOULDED-CAR-CARP ... dZViewItem

also need a manual peddle box suit v8 hydrolic

hey tom, you can convert your auto pedals to manual ones (same pedal box) by pulling the clip off the end of the pedal pivot and pull out the shaft. (use wd spray to help it slide out) swap your manual pedals onto the shaft and refit. usually takes 1/2 hour. i might have a hydraulic setup too, master,slave and line. are the clutch master bolts on the firewall, vertical or 45 degrees? craig

hi tom, sorry for being slow to reply. i have found the clutch master (45 degree) and slave with fluid line. they were used for about 18 months in my car but then was converted to auto. im looking for $40 the lot. parts are in south brighton. craig

still looking for

a holly 600-750 carby
V8 radiator and brakets