|
| delacaa |
|
||
|
Hi all.
For a while now my drivers seat in my EF has been broken....Well i think. When i sit on it you can tell something isnt right. It makes a click noise and does the same when i get out. I'm guessing a joint is broken in the frame. Has anyone had this happen to them? and how do i fix it? I was thinking i might try just going to a pannel beater, see if they know. Any ideas???????? Thanks
_________________ AARON |
||
| Top | |
||
| Paxton |
|
||
|
I've lost two supports that connect the Seat Base to the Adjusters in my XR6. I tried Aryldite, but that lasted about a week. I was going to contact a Welder to see if I could get the bracket welded to the base of the seat, but I managed to score a Leather Interior, so I'm not going to bother.
It isn't all that hard to remove the seat and take a look at what is the problem with it. Good Luck.
_________________ Gunmetal EF XR6 Auto
|
||
| Top | |
||
| fiend |
|
|||
|
Pulling out seats is easy. You need a Torx (Torq) 50 bit and socket wrench handle. I've sold five seats out of my trashed EF's to people who've destroyed theirs, same as you.
You can get the welded depending on where it is, but if it only makes a noise and doesn't bother you that much then why bother? |
|||
| Top | |
|||
| hans hartman |
|
||
|
delacaa wrote: Hi all. get a good seat from the wreckers and change your trim and covers over,to weld the frame you have to strip it to metal frame,weld or repair,then re trim it,foam and covers--if drivers seat it may be some time.
For a while now my drivers seat in my EF has been broken....Well i think. When i sit on it you can tell something isnt right. It makes a click noise and does the same when i get out. I'm guessing a joint is broken in the frame. Has anyone had this happen to them? and how do i fix it? I was thinking i might try just going to a pannel beater, see if they know. Any ideas???????? Thanks
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| delacaa |
|
||
|
Oh ok thanks for the help guys, yeah it annoys the hell out of me. So i'll look into it
cheers!
_________________ AARON |
||
| Top | |
||
| Private9 |
|
|||
|
I've had a few EF/EL's do this. It's very easy to remove the seat. The last one I did it wasn't cracked terribly so IIRC I used a couple of big washers and bolted the base back together.
Normally you'd get the base rewelded or go get another from the wreckers and swap your trim/foam cushion back on. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 90 guests |
