|
| robertf123 |
|
|||
|
Hey guys, after recently flushing my radiator and changing the overflow bottle on my EL 4l the LPG converter has frozen twice after a few minutes of driving im assuming that theres air getting into the converter and stopping it from warming up. Ive read that the solution to this is to bleed the converter but i have no idea how to. any input would appreciated, cheers guys
_________________ "I believe that Human beings and fish can peacefully coexist" - George W Bush |
|||
| Top | |
|||
| hans hartman |
|
||
|
pull 1 hose off and fill till the water is full in hose,or running out the coverter,also put heater to hot setting,may take a bit to bleed.run motor until normal temp. is reached,both hoses will be hot.
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| robertf123 |
|
|||
|
ok ill give that a go, does it matter where i pull the hose of though? is it better to pull it off from the thermostat housing or from the converter its self?
_________________ "I believe that Human beings and fish can peacefully coexist" - George W Bush |
|||
| Top | |
|||
| gogetta |
|
|||
|
ive had this problem on both my cars that have LPG and the only way I could stop it happening was to route the hoses to the converter properly...both times the original installation was done poorly and there was bugger all flow to the convertor...
dont know why but i had the cars for quite a while before they started having a problem, i tried a lot of things but re-routing was the only way to fix the problem in the end
_________________ |
|||
| Top | |
|||
| hans hartman |
|
||
|
robertf123 wrote: ok ill give that a go, does it matter where i pull the hose of though? is it better to pull it off from the thermostat housing or from the converter its self? off the converter,as its higher than the rest,if mounted on the tower.have a look-is it higher than the overflow bottle?if it is then its the highest point and gets all the air.
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| cjh |
|
|||
|
If it has genuine Ford fitted LPG system, there are 2, 10mm headed plugs that are underneath the converter. Take them out to drain oil that comes from the gas. This helps with idle quality.
That oil stinks too.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| robertf123 |
|
|||
|
cool ill give that a try a little later one, cjh, Im not too sure if its factory fitted, it is a vialle system though which im pretty sure is what they use out of the factory, this oil that drains out does that need to be replaced?
cheers
_________________ "I believe that Human beings and fish can peacefully coexist" - George W Bush |
|||
| Top | |
|||
| gogetta |
|
|||
|
yeah if its a tickford system i would highly doubt that the hoses would be the problem....but....I once had a problem with dirt/rust clogging up one of the outlets on the heater bypass tube...took the hose off and poked a small screwdriver down it and this fixed it...
_________________ |
|||
| Top | |
|||
| 89.SVO |
|
|||
Age: 35 Posts: 3382 Joined: 11th Mar 2008 Ride: EA SVO, AU2, Toyota Crown Location: Bendigo |
my XF did this exact thing. i put a new water pump on it and the new pump pressure pushed some rusty particles into the converter water jakcet, blocking it and causing it to freeze. if bleeding it doen't work try my idea meaning you'll have to pull the converter apart and put a rebuild kit through it
_________________ Daily driver: 2010 Toyota Crown hybrid 3.5L V6 hybrid. 254kw. |
|||
| Top | |
|||
| cjh |
|
|||
|
robertf123 wrote: cool ill give that a try a little later one, cjh, Im not too sure if its factory fitted, it is a vialle system though which im pretty sure is what they use out of the factory, this oil that drains out does that need to be replaced?
cheers No, its what comes out of the gas. If its genuine LPG system, it will have a Tickford LPG plate riveted on the car, usually on the pass side of the engine bay near the shockie mount.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| robertf123 |
|
|||
|
all fixed guys, just took one of the hoses at the converter and waited for the coolant to heat up and pump through, it looks like its heating up fine now. thanks for all the ideas guys
_________________ "I believe that Human beings and fish can peacefully coexist" - George W Bush |
|||
| Top | |
|||
| gogetta |
|
|||
|
ill bet the problem returns
_________________ |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 53 guests |
