|
| twr7cx |
|
|||
|
Changed the BEM in my EF to attept to fix the starting problem, and the Smartlock light is still not flashing. It's only been 5 minutes, but apparently it's ment to be flashing the immobolised code. Any ideas?
Last edited by twr7cx on Sat Oct 11, 2008 7:22 pm, edited 1 time in total. |
|||
| Top | |
|||
| twr7cx |
|
|||
|
found the answer here:
http://www.fordmods.com/forums/viewtopi ... t=changing bem good old xpression. And found the tech doc - http://www.fordmods.com/forums/Upgradin ... k-d47.html. According to both the Smartlock light should flash - so what if it isn't flashing? |
|||
| Top | |
|||
| asizzy |
|
||
|
I did the same but i went from low to high series green BEM and also Change your Dash loom it helps a great deal. You wont have to solder or mess around with wires and saves a lot of headaches.
_________________ AsIzZy |
||
| Top | |
||
| twr7cx |
|
|||
|
asizzy wrote: I did the same but i went from low to high series green BEM and also Change your Dash loom it helps a great deal. You wont have to solder or mess around with wires and saves a lot of headaches.
Going from low to mid, not low to high. They have the exact same amount of pins. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 55 guests |
