|
| DJ_Brown |
|
|||
Age: 37 Posts: 290 Joined: 10th May 2006 Ride: 5 Spd EA Wagon, 5 spd EF Fairmon Location: Melbourne |
Hello
I am going to install an EL XR6 Auto ECU into my EA manual.. When i did the manual conversion on my EF i remember from voxace's doco that there were some resistors involved for auto oil temp, and gear position.. On the EL ECU which pins should these go to on the ECU, and what resistors should they be?? Also, what happens without these on there?? Cheers David
_________________ If you're not driving a manual, you are only steering... |
|||
| Top | |
|||
| 66 coupe |
|
||
|
search for a thread / posts by troyman, he has the information i gave him within he's posts.
|
||
| Top | |
||
| frankieh |
|
|||
|
Yeah the auto bypass has been detailed well enough.. I just did this in my ea.. you'll need a smartlock bypass module as well.. (look on ebay)
|
|||
| Top | |
|||
| DJ_Brown |
|
|||
Age: 37 Posts: 290 Joined: 10th May 2006 Ride: 5 Spd EA Wagon, 5 spd EF Fairmon Location: Melbourne |
Thanks for the replys..
I still cant seem to find anything.. i tryed searching troyman's posts, but with so many of them, it was hard to pin point the one i needed.. thanks anyway, i'll try and figure it out.. David
_________________ If you're not driving a manual, you are only steering... |
|||
| Top | |
|||
| frankieh |
|
|||
|
Try here:
http://www.fordmods.com/forums/AU-4L-En ... n-d85.html 3/4 of the way down the page.... Auto ECU in Manual bypass |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 10 guests |
