I have an LPG electronic fuel processor from Gore Research on my 4lt EA-II. It is the Model FP6 which is the same as the FP9. My RDM1 Rotational Drive Motor has lost a couple of teeth on the final drive.

Does anybody have an old (circa '95) gas setup they are prepared to sell that is wired via the following;
1 wire to gas valve solenoid
1 wire to TP sensor output to ECM
1 wire to Oxygen Sensor output to ECM
2 wires to the rotational drive motor (usually yellow & blue)
1 wire to earth, either/and to engine block or ECM earth.

I really only need the motor, if it is the right one, however, I would be willing to buy the total electronic loom if required.

I'm looking to get this on the cheep as I am on the Disability Pension and cannot afford much.

A new setup is in the region of $250 (that's trade, I have a Capricorn No) and if it gets close to that I'll just bite the bullet and get one anyway.

Edit: Fixed subject line

i can get a new gas loom and stepper for 200 mate with the tuning lights on it to self tune
im in adelaide pm me if interested