|
needfordspeed |
|
||
|
Head and cam are still available, still need to get the head from the shop lol. But an almost identicle cam made 168rwkw with a stock tickford AU head and has run a 13 second quarter.
I'm not sure what the oil pump flows but it'd be useful to you as this was what I was going to use in my motor for a turbo setup, my engine builder recommended it.
_________________ 1988 EA S-Pack|MPI|LSD|AIT turbo manifold|Garrett GT3540|3" Exhaust turbo back|Resprayed|microtech LT8s|60lb Injectors|Bosch 044 with surge tank|3000 RPM stall|Ported AU head|Wade turbo cam|Crow double valve springs|1.3mm MLS headgasket|C4 conversion|Built bottom end|10.6@125MPHi |
||
Top | |
djcustomcomputing |
|
|||
|
How "ported" is it
is it taken out to the point ill loose heaps of fuel economy How hot is the cam is it mild bumpy idle what about the rocker gear is it included/in good cond depending on the answer to those to few U reckon u could do the reco ported head and cam ect for $750 also how good are the $150 set of valve springs if there good $900 sounds good to me the only problem ive just realised is postage because im in sa |
|||
Top | |
djcustomcomputing |
|
|||
|
I could try to organise a courier
|
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 11 guests |