Yeah ive heard it's a pain in the a** to put these in.Are the rails able to be changed over or modified to fit?Or should i give up and clean up the old seats and sell off the el seats.

They are a pain in the a** to modify but it can be done. I got around it by removing rear inside bracket from orig seat secure it to el seat(using high tensile bolts and re weld). Bolt down 2 rear brackets first and then front inside bracket(near console) and you will notice the front outside bracket near door wont match original hole on the floor pan so i drilled a hole in line with the bracket threw the floor and used a high tensile nut and bolt to secure it to the floor.
There are other ways ive seen this mod been done but ive found this to be the easiest and cheapest way of doing it. Now i just got to figure out how to line the EL back seat with the mounts/catch as the catch is about an inch to high.

do you have any pics of how it looks mate?
cheers

Will try 2 take some pics 2murra if time permits.

Here is pretty much the process with pics as promised

And there you have it EL seats (mind you this was using NL ghia seats but same process) into EA,EB and ED

 

 

Attachments:

EL seats installed.JPG [ 33.83 KiB | Viewed 251 times ]

that looks quite simple
cheers for that info mate

It is pretty simple and str8 forward i didnt go into to much detail with the process but if you get stuck just post ya question in this post and ill help you out