Does any1 have a wiring diagram for putting a EL/AU BBM on my AU motor in my EB S1 which was running a log manifold. And also a list of parts that are needed to do the conversion, and any other info i might need for the conversion. And is there any difference between the EL and AU BBMs? Cheers

look in the faqs up the page a bit. and in the ecu section. this'll probably answermost of your questions.

It is quite simple. You need the plug off an EL TPS. Solder it to the loom off the log manifold where the original TPS was. You will also need to extend the wires due to the different position of the throttle body. The best way is to lay the log loom on the BBM and identifiy where all the sensors and plugs are on the BBM, then extend/change the log loom where necessary.



The BBM with throttle body.
EL metal heater hose from lower thermostat housing.
EL metal heater hose from rear of water pump that goes under exhaust manifold and around the back of the engine.
EL heater/water hoses.
The fuel lines are different and depending on how much of them you get with the manifold will determine how you go about attaching them.
EL airbox, intake and piping.
EL throttle cable and pedal.




Yes there is. You need the EL BBM as the AU has different fittings specific to the AU that are not compatable with the E series.

Hope that helps

BenJ

cheers benj that helps alot.