|
wtbdlltd |
|
||
|
Todays progress not bad.
soldered back on the ECU loom ran most of engine bay wires etc, put carpets back in finished of door trims and put ef dash in. most of engine loom not finished yet but could not help myself and put the key in a turned it, all lights and everything cam on but got the smart lock flashing like crazy and the Light charm on constantly until i unplugged the battey, will look at that tomorrow, You do not have the required permissions to view the files attached to this post. |
||
Top | |
wtbdlltd |
|
||
|
2 things i cant work out, i cant fit the Vaccum unint on the heater box behind that dash it just wont allow the dash to go back far enough, are the NC and NF ones different?
Also since changing the Dash skin over to the dual air bag one the glovebox clip would not fit so have to work out another way of securing the glove box |
||
Top | |
wtbdlltd |
|
||
|
It lives, got the rest of the loom plugged in, hooked up a battery and turned the key over, fuel pump primes all dash lights come on and it says i have no fuel witch is right, smart lock is flashing like crazy still, have to put in learn mod apparently, not sure how if anyone knows what to do.
need to change the altenator plug as the NF one is 2 pin and the NC one is 3 pin. Other than that its pretty much finished |
||
Top | |
fairlane6970 |
|
|||
|
Welcome to the big a** Fairlane lwb world nice mods so far!
_________________
|
|||
Top | |
fairlane6970 |
|
|||
|
Welcome to the big a** Fairlane lwb world nice mods so far!
_________________
|
|||
Top | |
wtbdlltd |
|
||
|
just cant wait to drive it again has been 2 weeks, need to fix steering column issue first. might go get a EF one from a wreckers or something,
|
||
Top | |
SLO247 |
|
||
|
I'd give you the column from mine but I need it to steer it!
You sure it wont fit somehow? To train the BEM to the key, just leave the car in the Key on engine off position for an hour. |
||
Top | |
XFWAGON |
|
|||
|
Very noice!
I have spotted a DL around the corner which I hope to buy and swap the interior over, put the DC interior into storage. How hard have you found it? Were there that many extra holes needed to be drilled? |
|||
Top | |
wtbdlltd |
|
||
|
99% of everything fitted, had to trip 1 grommet hole on the fire wall to fit the big EF Loom plug,
Door handles needed new holes other that that all the same. will have to put new holes in when i do the handbrake also EF seats dont fit so have to work out a way to mod them to fit the NC floor pan |
||
Top | |
BenJ |
|
||
|
Re the climate control vacuum unit, yes you have to relocate it.
I put mine nearer the centre console. Built some brackets to suit. Cheers BenJ
_________________ {DESCRIPTION} - Current Ride |
||
Top | |
wtbdlltd |
|
||
|
{USERNAME} wrote: Re the climate control vacuum unit, yes you have to relocate it. I put mine nearer the centre console. Built some brackets to suit. Cheers BenJ Thanks BenJ, was going to do something like that. all is working on it now just need to figure out how to put the NF seats in and getting a EF steering column next week then she will be on the road |
||
Top | |
wtbdlltd |
|
||
|
Ok few issue's
When i start the car the D light on the dash for the gear selector flashes for a while and the P light wont come on when its in park. Car feels like its miss firing really bad or only on 5 or 7 cyls. any ideas? maybe i need the Auto Gearbox control unit from the EF aswell? Also when car fires up thermo fans come on full pelt constantly |
||
Top | |
wtbdlltd |
|
||
|
Ok well pretty much finished now. just need to fiddle with a few bits and pieces.
Put the EF seats in, i took the inter brackets from the NC seats and bolted them to the rear inner of the Ef ones, seems pretty good but it site about 10mm to high in that corner will work with it. All trims dash blah blah finished all electrics work other than climate control as i have not relocated the vacuum unit as yet. Still need to get a EF steering column or modify the NC one to fit on the Ef dash and box. Pic bellow You do not have the required permissions to view the files attached to this post. |
||
Top | |
wtbdlltd |
|
||
|
here is some pics of the seat mounts
You do not have the required permissions to view the files attached to this post. |
||
Top | |
wtbdlltd |
|
||
|
well i took it for a spin and it missfires like a dog, wont idle its like its on 6cyls, not sure were to start looking
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 25 guests |