|
frd906n |
|
||
|
Havent updated this in a long time
Well i found my self a job finally, been working since before xmas Nothing much has been done to the car expect Having to replace the radiator, as something had put a hole in it and it started leaking everywhere, So i replaced that to find that the transmission oil kept leaking out the trans cooler in the radiator for some reason, they reckon that it was my trans line, But i decide instead of stuffing around just to buy a trans cooler and get it installed So all thats fixed, waiting for my spare rim to come back from getting repaired repairs becuase the other day when it was pissing down with rain i hit a pot hole with the left hand side rim and it bent it Still drives normal but the steering wheel has a slight shudder to it Should have the rim sorted out hopefully this week with a wheel alignment and balance Got my cruise control buttons put back in finally as well, yay Also orderd my stone tray from ford as well, and got a bag of 20 scrivets from a memeber on aff Also by chance at the wreckers the other day i came across a gold au with very good front guards, paint in very good condition, no dents and just slight marks which will buff out, couldnt get a front bar though as they were all stuffed So ill just order a brand newy in primer and put that on the same time as i put my inner gurads back in and the new front guards as well Also orderd another header tank to replace my murky looking one as well But yeh been quiet busy with the car lol,
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
Top | |
huggiebear |
|
|||
|
frd906n wrote: Nothing much has been done to the car expect But yeh been quiet busy with the car lol, umm ok? frd906n wrote: So i replaced that to find that the transmission oil kept leaking out the trans cooler in the radiator for some reason, they reckon that it was my trans line, oil IN your radiator is faulty lines on the car.. umm at which point does the gearbox fluid mix with water apart from in the radiator? they are spitting you s**t. if oil is leaking in then water will be leaking out which will root your box or if you bypassed it like i do then it will drain and blow your motor |
|||
Top | |
frd906n |
|
||
|
lol the transmission lines run to the trans cooler in the radiator, where else would i run the trans lines to also at what part of my post did i mention it was mixing with the water etc
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
Top | |
frd906n |
|
||
|
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
Top | |
barnzey_92 |
|
||
|
not a fan of the au but i like yours looks nice keep up the good work mate
jake
_________________ Ba Xr6: running lpg lowed with super lows and a GME uhf! |
||
Top | |
frd906n |
|
||
|
Wow been a while since ive been on here
The other day i decide i had enough of the cat converter which came with the exttractors, So i bit the bullet and got my self a high flow cat and got the pipe redone at the same time, Cost me 250 fitted. When i drove it home it souded a little ricey but soon as it carboned up, the exhuast hella lot better then before ill have to get a vid
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
Top | |
frd906n |
|
||
|
Since getting the cat converter put on i found a spoilerless boot lid i got off my au wrecker and got it fitted
Looks hella alot better then it did before Also i have decided to go back to stock 15 or 16 inch rims for the time bieng So if any one is interested in buying my 18s or doing a swap let me no cheers matt
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
Top | |
Teknoslasher |
|
|||
Age: 38 Posts: 138 Joined: 13th Sep 2010 Ride: '96 EL Ford Fairmonth Ghia. Location: Toowoomba |
Hey buddy, how's the build going?
_________________ |
|||
Top | |
frd906n |
|
||
|
Well i say good bye to the AU in a months time, been through hell and back with the car and the highs and lows as well
Ill trade it in and see what i get if i dont get anything due to the high ks i will strip it out and sell all the bits off Im getting a brand new Toyota hilux cab chassis 2.7 litre manual No need for a sedan speacially when im a tradie I will still be around the forums Cheers Matt
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 5 guests |