|
| TURBO_GHIA |
|
|||
|
hey mate , how did you go wiring the T56 up . ?
_________________ HMMMM BOOST !!!
|
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
I just have to wire in speedo , but need the box from jaycar . didnt worry about the reverse lock out solenoid as i had to modify the offset lever . about to bleed the clutch now then have a good look at everything to make sure its ready for the tune .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Its ready for a tune, put a 10 psi spring in the waste gate . was 16 before .
{DESCRIPTION}
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Falcon96XR6 |
|
|||
|
Nicee!!
Cruise soon! Haha, Gotta get mine tuned now.. After I sort this dodgy idle haha
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Yes , Will have to go on a cruise once its tuned .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Taking it in for a tune on Wednesday . if all goes well i will be driving it again . hasn't been driven for about 2 years since i pulled it off the road to turbo it .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Started it today and took it for a drive out the front .
Idle is a bit rough and stalls if not reved up when Im taking off , bit of shudder but that's expected with the clutch I'm running . Getting a trailer tomorrow so its all ready to go .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Got it on the dyno today. Made 235 rwkw at 9 psi . getting a few km on the engine then going back turning boost up to 12-14 psi
_________________ El XR6 Turbo |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
Got it on the dyno today. Made 235 rwkw at 9 psi . getting a few km on the engine then going back turning boost up to 12-14 psi
_________________ El XR6 Turbo |
|||
| Top | |
|||
| xcabbi |
|
||
|
That's a pretty reasonable result. Bet you'll be glad to be driving it again.
|
||
| Top | |
||
| ef_falcon_95 |
|
|||
|
Very happy to be driving it again .haven't taken it for a drive yet had to put a hose clamp on the clutch bleed hose it popped off the barb fitting . I have braided lines made up so if the hose pops off the slave cylinder I'll have to take the gear box out to put the braided hoses on .
Taking it for a drive tomorrow .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| Falcon96XR6 |
|
|||
|
235rwkw is a nice number, would cirtainly liven it up abit more haha,
You'll drive it tomorrow and fall back in love with it 
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| ef_falcon_95 |
|
|||
|
I already have lol.can't wait to drive it tomorrow . I'll have to spray and fit the tickford body kit I've had sitting around , to finish it off .
_________________ El XR6 Turbo |
|||
| Top | |
|||
| SWC |
|
||
|
Well done Corey. Long time coming.
Enjoy. |
||
| Top | |
||
| Falcon96XR6 |
|
|||
|
Definitely, your EL is tidy as it is now, the kit would set it off nicely,
Needs a good polish tho, (from the last time I seen it anyway)  haha
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 39 guests |
