|
| BenJ |
|
||
|
The Gregorys Manual has instructions on how to make a tool.
It is basically a flat piece of metal approx 20mm wide bent over at the ends. The bent over end parts get a slot cut into them that slips over the fins on the fuel tank cap. In the centre of the tool you can make a hole and file it square to fit a 1/2 inch drive ratchet. Hope this helps. Cheers BenJ
_________________ {DESCRIPTION} - Current Ride |
||
| Top | |
||
| Shifteh |
|
||
|
ive got my p's now , will have to set up a cruise or something sometime , :d
_________________ Crank Assembly balanced, HV oil pump, ACL Trimetal bearings, "1 extra oil clearance taking to around 0.0650-0.0700 on mains and big ends, Moly rings,, Xr6 Cam, POD ( Possibly oversize injectors), Block, Head, Timing cover, belt idler, Alternator,painted in ford light blue |
||
| Top | |
||
| XD VAN 82 |
|
|||
|
{USERNAME} wrote: The Gregorys Manual has instructions on how to make a tool. It is basically a flat piece of metal approx 20mm wide bent over at the ends. The bent over end parts get a slot cut into them that slips over the fins on the fuel tank cap. In the centre of the tool you can make a hole and file it square to fit a 1/2 inch drive ratchet. Hope this helps. Cheers BenJ thanks for the reply BenJ i was speaking to my brother in law he has a tool to lend me so ill have the pump done during the week.
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
{USERNAME} wrote: ive got my p's now , will have to set up a cruise or something sometime , :d nice, yea id be keen for a cruise at some stage.
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
Updates: Borrowed a tool off my brother in law and got the fuel pump swapped over last week, got the tail pipe fitted on saturday put it on the hoist at my brother in laws work and while we were there welded on a 3 inch dump tip, tips abit crooked not to notice able the exhaust is very quite it only has 1 straight through muffler so i thought it would have a decent note to it but it sounds almost stock. I also got a large PWR trans cooler off lukey_1990 i have it mounted on the car so it doesnt get damaged in the garage just have to get around to hooking it up. and finally i have started prepping the rear bar for paint.
   The XF: its nearly ready to take for a run i got it fired the other day just need a fitting for the manifold for the heater and brake booster. ive made some measurements for the throttle cable and choke cable, i also have to get the old welsh plugs out wich is proving to be a pain the extractors are welded to the exhaust so theres isnt a great deal off room in there.  
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| ToranaGuy |
|
|||
|
Wow man, busy much lol! Update since I've last read looks good, the ED is looking s**t hot! Pitty about your job, hope you have got something lined up.
Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|{DESCRIPTION}|{DESCRIPTION}|{DESCRIPTION}| |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
{USERNAME} wrote: Wow man, busy much lol! Update since I've last read looks good, the ED is looking s**t hot! Pitty about your job, hope you have got something lined up. Cheers ToranaGuy i like to keep my self busy  thanks mate, bit of a bugger about my job nothing really lined up just sending out resumes and dropping some off hopefully find something soon.
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| ToranaGuy |
|
|||
|
I too like to keep myself busy, almost to the point of silly lol.
Hope a job comes your way sooner rather than later. Good luck with the hunt. Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|{DESCRIPTION}|{DESCRIPTION}|{DESCRIPTION}| |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
{USERNAME} wrote: I too like to keep myself busy, almost to the point of silly lol. Hope a job comes your way sooner rather than later. Good luck with the hunt. Cheers ToranaGuy theres always things to be done. thanks man im hoping something pops up pretty soon.
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
got the bar ready for paint today its not perfect im not fussing with it to much i mainly fixed the most noticeable things. ill be putting some colour on it tomorrow and should have it fitted to the car.
put some high build putty on  sanded it smooth and put some primer on 
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
got the bar painted up today ill fit it tomorrow.
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| ToranaGuy |
|
|||
|
Nice work! All I got done today after work was topping up my gearbox oil & running a code scan on the ecu.....it's something but it never seems like enough lol.
Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|{DESCRIPTION}|{DESCRIPTION}|{DESCRIPTION}| |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
{USERNAME} wrote: Nice work! All I got done today after work was topping up my gearbox oil & running a code scan on the ecu.....it's something but it never seems like enough lol. Cheers ToranaGuy thanks man, something is always better then nothing
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
fitted the bar yesterday then vaccumed it out and gave it a wash.
 photos i took today    
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| XD VAN 82 |
|
|||
|
Updates:
ED: i went to repco the other day and decided to finally get new speakers ive only been driving it for a few months with no radio  so i grabbed 2 sets of fusion speakers for $59 on sale usually $89 they seem pretty good i have the tweeters mounted in the door trims and also ran all new wiring for all the speakers to the head unit before they would keep cutting out then stopped working all together.XF: The other day i grabbed a throttle cable and manual choke for the holley i started fitting them up today throttle cables pretty much done i just need to pull the wheel off so i can bolt the bracket to the shock tower. tomorrow ill head out and grab something to bolt to the manifold that will come out far enough for the throttle return spring because the throttle just stays open at the moment. Sunday my brother in law comes up to have a go at the welsh plugs if all goes well it should be running sunday morning and he can help me tune it.
_________________ Daily: 1994 EF Falcon GLI, few mods with many more planned. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 17 guests |
