|
| hillendcar |
|
||
|
i am after help on fitting a el hand break to my xh,my question is how do you make the connection from the el front cable to the pivot point of the rear cable,if you have done this i would appreciate your help,even if you have a thread on this would be great...Brian
|
||
| Top | |
||
| hillendcar |
|
||
|
ashcook wrote: Hey Brian, When I did mine, I used the EL XR diff, so I had a straight connection. But previous I had simply used some cable clamps, you know the D-shape ones, run the cable through the joiner and clamp it off at the right length. May be a little dodgy but it held well and worked all the time. cheers, Ash thanks for that,i might see if i can get the cable made shorter,i will look around..Brian |
||
| Top | |
||
| hillendcar |
|
||
|
ashcook wrote: We use to sell cable ends and different pieces when I was working in a few motorbike shops. They simply solder on. You could try them, I know there isn't one close to you but you could give that a shot. that sounds like the answer,i will get my son in Syd to look into that,thanks ash |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 7 guests |